Mindeo FS580, User Manual

Page: 92 / 114

86
5-11 PARAM_DEFAULTS
Description: Set the parameters to default values
Packet Format
Length Opcode Status Setting type Checksum
0x04 0x25
Field Descriptions
Field Name Format Size Description
Length 0x04 1 Byte Length Field
Opcode 0x25 1 Byte Identifies this opcode type.
Status
Bit 0: Identifies transmit status
Bit 6-1: Unused
Bit 7: Command source
1 Byte
Bit 0:
0=First time packet is sent
1= Subsequent transmission
Bit 7: always be 1(message is from the host)
All unused bits recommend to be set to 0.
Setting type Default setting type 1 Byte
0-255.
0: Default setting 0 (Mindeo standard)
Checksum
2's complement sum of message
contents excluding checksum.
2 Bytes Checksum of message.
For example: return all parameters to the factory default setting values.
Length Opcode Status Setting type Checksum
0x04 0x25 0x80 0x00 0xFF 0x57
Host Requirements
The host sends this command to reset the scanner’s parameter settings to the factory default values.
Scanner Requirements
Upon receiving this command, the scanner’s resets all parameters (except Scan mode) to the factory
default values. The behavior is the same as scanning factory defaults configuration barcode, see section
“ 11 Return default parameters & firmware version ”
.