mind alive DAVID ALERT, Operator'S Manual

Page: 8 / 15

Page 8
for the “A” group to finish and the “B” group will scan, followed by group
“C”. Pressing the INT button will allow you to scan through the sessions
faster. Once a session has been selected, the session number will flash a
few times, then scroll from 1 through 6 to indicate Soft On (eyeset lights
and headphone volume will start low and gradually increase over ten
seconds until the levels reach the preset settings of intensity and volume).
This allows you time to put on the eyesets and headphones. During the
remainder of the session, the session light (eg. A1, B4) will flash briefly
every few seconds to remind you of the session number selected. Every
eighth flash will show the battery power level (1 to 6). As the session ends,
the eyeset lights and volume will fade out (Soft Off
TM
). The number
display will scroll from 6 through 1 to indicate Soft Off
TM
. If no buttons are
pressed, the ALERT will go into standby in two minutes. The green PWR
light will remain dimly lit reminding you to turn the ALERT off.
Selecting Heartbeat
All of the ALERT sessions (except Sound Sync Session - C6) begin with
the heartbeat on. To turn to heartbeat off, press and hold the SEL button for
approximately one second. To turn the heartbeat back on, press and hold
the SEL button again for approximately one second.
Selecting Pulsed Tone/Binaural Beats/Chime
All of the ALERT sessions (except session C6) begin with the Classic tone
on. Press the SEL button once to select Binaural Beats. Press the SEL
button again to select Chime. Press SEL once more to turn all tones off.
Pressing the SEL button again will turn the Classic tone on again.
Adjusting Volume
Note: The volume button (VOL) is raised to guide you to locate button with
eyes closed during sessions. To increase the volume of the tones through the
headphones, press and hold the VOL button. To decrease the volume,
release VOL button and press and hold again. Or you may press short
single steps for small adjustments in the volume. The indicator lights 1 to 6
will show the volume level.
Adjusting Intensity
Note: The intensity button (INT) is raised to guide you in locating button
with eyes closed during sessions . To increase the intensity of the lights in
the Omniscreen eyeset, press and hold the INT button. To decrease the
intensity, release the INT button and press and hold again. Or you may
press short single steps for small adjustments in the intensity. The indicator
lights 1 to 6 will show the intensity level.