Minarik C1MMXL05-D240AC, User Manual

Page: 35 / 44

Before troubleshooting
Perform the following steps before starting any procedure in this
section:
• Disconnect AC line voltage from the drive.
• Check the drive closely for damaged components.
• Check that no conductive or other foreign material has become
lodged on the printed circuit board.
• Verify that every connection is correct and in good condition.
• Verify that there are no short circuits or grounded connections.
• Check that the voltage selection switch settings match the AC
line and output voltages.
• Check that the drive’s rated armature and field outputs are
consistent with the motor ratings.
For additional assistance, contact your local Minarik® distributor,
or the factory direct:
(800) MINARIK (phone) or (800) 394-6334 (fax).
27
Troubleshooting
Warning
Dangerous voltages exist on the drive when it is powered.
When possible, disconnect the drive while troubleshooting.
High voltages can cause serious or fatal injury.
250-0277.qxd 6/9/00 1:00 PM Page 27