ENG
10
3.3 WALL B SUPPORT
REF
MODEL
DESCRIPTION
B0101800
WALL B SUPPORT
Reinforced wall B bracket. 7 cm shaft-wall separation.
Installation and assembly
- Check that the wall is sufficiently hard-wearing and flat.
- Use the bracket to mark the holes on the wall with the help of a pencil (1).
- Drill holes and put the plugs into the wall (1).
- Position the wall support, lining it up with the location of the holes (2).
- Tighten the screws until the assembly, the guide separator and the screw are firmly attached
(2).
- Once the support is fixed and secure, position the lamp through the upper hole (3).
Install the accessory without the lighting unit installed on it.
It is the customer’s responsibility to ensure that the surface that it is attached to is
secure and sufficiently strong.
The bracket is only designed to support the weight of the lamp. If additional weight is
added, this may cause damage to the lighting unit and/or injury to the user.
Check regularly that the unit is still stable in order to avoid the possibility of the
lighting unit falling down.
