MIMAKI UJF-3042FX, Operation Manual, Page: 36 / 146

2-6
Test drawing
Make test drawing in the specified direction to check whether there is nozzle clogging or other drawing failures
(such as wearing or missing).
1
Press the key in the local mode.
2
Select the drawing direction by pressing the
or key, and press the key.
• When nozzle recovery is not set, test drawing is started in the
selected direction.
• SCAN DIR: Draws in the scan (widthwise) direction of the media.
• FEED DIR: Draws in the feed (longwise) direction of the media.
3
When nozzle recovery is set, press the or key
to set ON/ OFF and then press the key.
• This is available for F/W Ver.3.30 and later.
• ON: Draws with nozzle recovery ON.
OFF: Draws with nozzle recover OFF.
4
Test drawing ends.
• Y-bar evacuates from the table, and then the mode returns to the local.
5
Check result of drawing.
• When the result is normal, finish the operation. ( P.2-9)
• When the result is abnormal, execute head cleaning. ( P.2-8)
Check before starting
test drawing
• Is media set? ( P.2-4) • Is origin point set? ( P.3-2)
< L O C A L >
TEST
T E S T D R A W
( S C A N D I R ) < E N T >
T E S T D R A W
( F E E D D I R ) < E N T >
ENTER
When FEED DIR is selected
When SCAN DIR is selected
T E S T D R A W
N O Z Z L E R E C O V E R Y : O N
ENTER