MIMAKI SWJ-320 S2, Maintenance Manual

Page: 49 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.1 P.1
R.1.1
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > HEAD ADJUST
Model SWJ-320S Issued 2012.07.19 Revised 2013.03.08 F/W ver 2.20 Remark
1.1
Rev.
4.2.1 HEAD ADJUST
 Outline
Adjust the head tilt, the forward/backward position of adjacent heads, stagger position (SWJ-320S4 only).
SWJ-320S series offer following 2 ways to adjust the print head.
1)Adjust slant, stagger, and position at the same time by [AVERAGING ADJ.].
<
Advantages>
 No feed is in, and thus no substantial effect of media’s skew.
 Given that slant, stagger, and position can be adjusted at the same time, adjustment in short time is
possible.

Image quality is better in Bi-d printing rather than adjusting slant by [SLANT ADJUST]
<
Disadvantages>
 Image quality is deteriorated in Uni-d printing rather than adjusting slant by [SLANT ADJUST]
2)Adjust slant, stagger, and position separately by [SLANT ADJUST]/[STAGGER ADJUST]/ [POSI-
TION ADJUST].
<
Advantages>
 Image quality is better in Uni-d printing compared to adjusting slant with [AVERAGING ADJ.]
<
Disadvantages
>
 In [SLANT ADJUST], maladjustment may occur by the effect of media skew.
 Slant, stagger, and position cannot be adjusted at the same time, and thus it takes time.
 Image quality is deteriorated in Bi-d printing compared to adjusting slant with [AVERAGING ADJ.]
When the head adjustment is incorrect, be sure to execute the adjustment since it affects other
parameter adjustments.
 The development department recommends adjustment by [AVERAGING ADJ.], which adjustment
time is short, and image quality is better in Bi-d printing.
 The head is adjusted by [AVERAGING ADJ.] at the time of shipment from the factory.