MIMAKI CJV30 Series, Maintenance Manual

Page: 234 / 316

© 2009 MIMAKI ENGINEERING CO.,LTD. 6.5.10 P.1
1
2
3
4
5
6
7
8
R.1.1
Maintenance Manual > Disassembly and Reassembly > Electrical Parts > Cutter Slider PCB Assy
Model CJV30/TPC Issued 2008.08.04 Revised 2008.09.17 F/W ver. 1.20 Remark
1.1
Rev.
6.5.10 Cutter Slider PCB Assy
 Work procedures
1. Remove the C head cover .
2. Disconnect all FFCs and cables from PCB.
After turning off the main power supply switch, make sure to take 15 minutes before restarting the operation.
It is very dangerous if sleep mode functions mistakenly during the operation.
Moreover, the PCB may be damaged in case electric charge still remains inside.
After turning off the sub and main power switches in order, unplug the power code.
Check if no electric charge is remaining in the PCB.
Refer to the "4.5.2 Electric charge checking when replace the Electrical Parts"
It is very dangerous if sleep mode functions mistakenly during the operation.
Moreover, the PCB may be damaged in case electric charge still remains inside.
Also there is a possibility of electric shock because of high power voltage applied the high-pressure part
of the power supply PCB assy. Take care to avoid contact with it.
Cutter Slider PCB Assy