MIMAKI CF3-1610, Operation Manual

Page: 151 / 166

6-17
Tr
oublesho
oting
6
Problems Causing an Error Display
A message appears on the screen when an abnormality occurs in this unit.
Take the appropriate remedy for the displayed message.
Non-fatal Errors
Display Cause Remedy
ERROR 10 COMMAND
ERROR 11 PARAMETER
ERROR 12 DEVICE
Communications conditions differ in
plotter and PC.
Match the communications
conditions. (
P.1-34)
ERROR 13 POLYGON The polygon buffer overflowed. Break up and send the polygon data.
ERROR 20 I/O Communications conditions differ in
plotter and PC. Match the communications
conditions. (
P.1-34)
The plotter was turned on while the
PC was turned off. Turn the PC on before turning the
plotter on.
ERROR 27 BUFFER OVER A serial interface error occurred. Match the communications
conditions. (
P.1-34)
ERROR 30 OPERATION An illegal key operation was made,
such as changing the
communications conditions while
cutting was interrupted.
Do not make illegal key operations.
An ASCII dump was made with an
effective area less than A3.
Set the effective area to at least A3
size before conducting an ASCII
dump.
An ASCII dump was made with the
origin set at a position that does not
allow an effective area of A3 to be
obtained.
ERROR 31 NO DATA The copy function was used with no
data received. Before using the copy function,
receive the data from the PC and cut
it. (
P.3-4 "Cutting the Same Data
Again (Copy)")
ERROR 32 DATA TOO LARGE An attempt was made to copy data
exceeding 1 MB in size.
Send data less than 1 MB in size.
ERROR 36 MARK DETECT The register marks could not be
detected. Check if the paper is curled.
Check if the register mark detection
start point is designated correctly.
(
P.4-11)
Check if black or white register marks
are printed.
Check that there is no printing or dirt
between the register marks.
Check that all the register mark
detection settings are correct.
(
P.4-9)
Contact your dealer or an office of MIMAKI if these remedies do not work and
register mark detection is not possible.