MIMAKI CF3-1610, Operation Manual

Page: 137 / 166

6
6-3
Tr
ou
bleshoo
ting
Adjusting the Tools
Tool adjustment is required if the start and end points do not match when cutting (drawing) with the unit.
Tool adjustment is possible only when using Model R1 or Model TF2.
The following four tool adjustments are available:
(1) Cutter adjustment................... Adjusts the cutter mounted in Head B or C.
(2) Roller adjustment ................... Adjusts a roller mounted in Head C.
(3) Circle
θ
correction .................. Adjustment if start and end points do not match when cutting (drawing) a circle.
(4) Light pointer adjustment......... Adjustments when the register marks cannot be detected.
Adjusting the Cutter
Adjusts the cutter mounted in Head B or C.
The following adjustments are available to adjust the cutter.
●
For more efficient cutter adjustment, follow the sequence below:
Z
D
X
D
Y
D
X
D
Y
D
Z
This sequence is one recommended example. Set in a sequence that will be convenient for you.
• A roller can be adjusted in the same way.
X
Adjust Eccentricity
P.6-6
Make this adjustment after replacing the
blade or the tool.
Y
Adjust
θ
Angle
P.6-8
Adjusts the cutter and
roller angle of rotation.
Z
Adjust Offset
P.6-4
Adjusts for displacement
between the cutter and tool positions.
< AD J > CENTER 1 / 3
A ( L ENG ) + 0 0 . 0 0 >
B + 0 0 . 0 0 >
TES T PAT T ERN - >
Adjust Eccentricity
< AD J >
θ
2 / 3
CUT TER
θ
+ 0 0 0 0 >
PA T TERN N o . 1 >
TES T PAT T ERN - >
Adjust
θ
Angle Screen
< AD J > CENTER 3 / 3
CUT TER X + 3 6 . 4 0 >
CUT TER Y + 4 5 . 4 0 >
TES T PAT T ERN - >
Adjust Offset Screen