4
ASSEMBLY
WARNING
Recharge only with the charger
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove the battery pack
any time the tool is not in use.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
reco
Only use
mmended
accessorie
for thi
s
s tool. Others
may be hazardous.
Installing/Removing/Cleaning
the Dust Screen
Using the dust screen will increase the performance
and extend the life of the tool.
1. To
attach
the dust screen, snap the screen over the
tool’s handle.
2. To
remove
into the notch at the top of the dust screen and pry
away from the tool.
3. To
clean
the dust screen, tap against a hard surface,
or blow clean with compressed air.
CAUTION
Do not use tool without dust screen
installed.
SYMBOLOGY
Volts
Direct Current
No Load Revolutions per Minute (RPM)
Read Operator's Manual
SPECIFICATIONS
Volts........................................................... 18V DC
Battery Type .................................................M18™
Charger Type................................................M18™
Recommended Ambient
Operating Temperature ................... -17°C to 51°C
(0°F to 125°F)
Rated RPM .............................................. 0 - 5,100
Pad Diameter........................................150mm (6")
FUNCTIONAL DESCRIPTION
1. Pommel handle
2. Tool rest
3. Speed control dial
4. Handle
5. Trigger
6. Trigger lock
7. Dust screen
8. Backing plate
9. Polishing pad
(not included)
3
8
4
2
6
9
1
7
5
Cat. No........................................... M18 FDAP150
WARNING
WARNING
To reduce the risk of fire, personal
Do not charge non-rechargeable
batteries.
ADDITIONAL BATTERY SAFETY RULES
injury, and product damage due to
a short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow inside
them. Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a
short circuit.
Regulatory Compliance Mark (RCM).
This product meets applicable
regulatory requirements.
Do not dispose of electric tools
together with household waste
material. Electric tools and electronic
equipment that have reached the end
of their life must be collected
separately and returned to an
environmentally compatible recycling
facility.
WARNING
•
•
WARNING
Some dust created by power sanding,
sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• lead from lead-based paint
• crystalline silica from bricks and cement and other
masonry products, and
• arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to
To reduce the risk of injury, when
working in dusty situations,
wear appropriate respiratory protection or use
a suitable dust extraction solution.
Always use common sense and be cautious
when using tools.
It is not possible to anticipate
every situation that could result in a dangerous
outcome. Do not use this tool if you do not
understand these operating instructions or you
feel the work is beyond your capability; contact
MILWAUKEE
®
Tool or a trained professional for
additional information or training.
Maintain labels and nameplates.
These carry
important information. If unreadable or missing,
contact a
MILWAUKEE
®
service facility for a
replacement.
Additional Safety Warnings
