= WIRE TRAPS
or GUIDES
Wire Ribbon
LED Assembly #76
LED Tray #70
Route sleeved wires of the LED
Assembly #76 as shown, pressing/
trapping sleeve up into the LED
Tray #70. Place tray into the
top groove between
gearcase halves
and tighten
screws.
Connector from
LED Assembly #76
Connector from Control
Board/Terminal
Connector Block #51
+
+
Control Board/
Terminal Connector Block #51
On-Off
Switch #59
Mark
IMPORTANT:
For proper installation,
this black wire has a
mark on it that must be
placed in the wire trap
as shown.
High Voltage
Wire #92
Prior to installing the LED and Tray
Assembly #90, route High Voltage
Wire #92 around and through the
Motor Cage Assembly #89 as shown.
Secure to the Gearcase Halve #28
with Screw #29.
High Voltage
Wire #92
Closed End
Connector #93
NOTE:
Right Motor Cage #52 may not
have additional wire traps for
the High Voltage Wire. Use a
dab of RTV at these points
to hold wire in place.
High Voltage
Wire #92
Short black wire off
negative terminal
Closed End
Connector #93
Strip short black wire (from the negative
terminal of the Control Board/Terminal
Connector Block #51) to about 3/16”.
StripHigh Voltage Wire #92 to approxi-
mately 3/16”. Twist the metal strands of
both wires together. Twist a Closed End
Connector #93 over the wire strands.
Crimp the barrel of the connector to
secure the wires. Route the High Voltage
Wire as shown above starting with the HV
wire in the bottom of the LED/Terminal
connector cavity, under the joined
connectors.
