4
Installing/Removing the Accessories
To
install
the nozzles, line up the tabs on the nozzle
with the notches on the tube. Slide the nozzle onto
the tube until it snaps in place. Pull on the nozzle to
ensure it is secure. To remove, press the tabs in and
pull away from the tool.
Fuel Gauge
Use the Fuel Gauge to determine the lowest battery
pack's remaining run time. When less than 10% of
times. When the battery reaches 0% charge, 1 light
-
tery packs.
If the Fuel Gauge doesn't appear to be working,
place the battery pack on the charger and charge
as needed.
Immediately after using the battery pack, the Fuel
Gauge may display a lower charge than it will if
checked a few minutes later. The battery cells "re-
cover" some of their charge after resting.
Fuel Gauge
Lights
Diagnosis
Solution
Solid
Lights 1 - 4
run time
Remaining Continue
working
1 Light,
Less than
10% run time
left
Prepare to charge
pack
1 Light,
discharge
End of
Charge pack
SPECIFICATIONS
Cat. No. ................................................. M18 F2BL
Volts............................................................ 36V DC
Battery Type .................................................
Charger Type................................................
No Load RPM ...............................................16,750
Sound Pressure Level........................................ 83.0 dB(A)
Recommended Ambient
ASSEMBLY
Operating Temperature .................. -17°C to 51°C
Removing/Inserting the Batteries
To insert the batteries, slide the packs into the body of
the blower. Make sure they latch securely into place.
NOTICE
pack is charged.
•The blower will not work with only one battery pack.
•If one battery pack is completely discharged, the
blower will not function, even if the second battery
•
Max Air Volume....................................... 17 m³/min
Max Air Speed.......................................... 233 km/h
WARNING
Recharge only with the charger
specified for the battery. For
specific charging instructions, read the
operator’s manual supplied with your charger
and battery.
WARNING
Always remove the battery
packs any time the tool is not in
use.
The blower requires two charged battery
packs to operate.
For best results, use with (2)
MILWAUKEE
®
REDLITHIUM
TM
-ION HIGH OUTPUT
TM
8.0AH or
higher capacity battery packs.
WARNING
Only use accessories
specifically recommended for
this tool. Others may be hazardous.
Tube Assembly
To
install
, line up the tab on the tube
with the notch in the housing. Slide the
tube into the housing until it snaps in
place. Pull on the tube to ensure it is
secure.
To
remove
the tube for storage, press
the tube latch and pull the tube out of
the housing. Always re-install the tube
before use.
WARNING
To reduce the risk of injury, do
not operate blower without tube
securely in place. Never reach into blower
through tube hole.
To remove the batteries, push in the release buttons
and pull the battery pack away from the tool.
FUNCTIONAL DESCRIPTION
1. Flat nozzle
2.
3. Fuel gauge
4. Variable speed lock-on
5. Trigger
6. Handle
7. Air intake vent
8. Tube latch
9. Tube
6
4
7
9
5
8
3
1
2
Tapered nozzle