Auto-Start Mode
In Auto-Start mode, the motor will not start until pres-
sure is placed on the bit. Press the auto-start button
to turn auto-start on and off. The auto-start indicator
will light. Auto-start will remain on for 2 hours after
last use unless turned off.
Auto-Start
ON:
When the trigger is pulled, the motor
remains off until pressure is applied
to the bit. With pressure, the motor
turns on and the bit spins.
Auto-Start
OFF:
When the trigger is pulled, the motor
runs but the bit does not spin until
pressure is applied.
Trigger Lock-On
1. To lock the trigger
ON
for continuous use, pull the
trigger and slide the lock up. The LED will remain
on while the trigger is locked on.
2. To turn
OFF
the tool, pull and release the trigger.
Starting, Stopping and Controlling Speed
1. To
start
the tool, grasp the handles rmly and
pull the trigger.
NOTE:
A LED is turned on and remains on when
the trigger is pulled or locked on in both auto-start
ON and OFF modes. LED will go off about 9 sec-
onds after trigger is released.
2. Apply
pressure
to the bit to begin driving.
3. To
vary
the speed, increase or decrease the pres-
sure on the trigger. The further the trigger is pulled,
the greater the speed.
4. To
stop
the tool, release the trigger. Make sure
the tool comes to a complete stop before laying
the tool down.
Depth Adjustment Using Nose Cone
1. To
increase
the driving depth,
turn the depth adjusting collar
clockwise .
2. To
decrease
the driving depth,
turn the depth adjusting collar
counterclockwise .
Start with about 1.6 mm (1/16")
clearance between the head of
the screw and nose. Every two
clicks of the
depth adjusting collar equal 0.4
mm (1/64") in driving depth.
Continue adjusting the depth
locator to the desired depth.
1.6mm
(1/16")
Using the Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Always allow the motor
to come to a complete stop before using the control
switch to avoid damage to the tool.
For
forward
(clockwise) rotation, push the control
switch from the right side of the tool. Check the
direction of rotation before use.
For
reverse
(counterclockwise) rotation, push the
control switch from the left side of the tool. Check
direction of rotation before use.
To
lock
the trigger, push the control switch to the
centre position. The trigger will not work while the
control switch is in the centre locked position. Always
lock the trigger or remove the battery pack before
performing maintenance, changing accessories,
storing the tool and any time the tool is not in use.
WARNING
To reduce the risk of injury, keep
hands away from the bit and all
moving parts.
5
Summary of Contents for M18 FSGC
Page 7: ......
