Milwaukee M18 FSGC, Operator'S Manual, Page: 4 / 8

Attach the collated attachment
4
The chuck is removed from the tool before
attaching collated attachment.
Max Capacity ..................................... 55 mm (2.2")
For use with ....................................... M18 FSGC-0
M18™ FUEL™ Drywall Screw Gun
1. Screw length indicator
2. Screw length adjustment
lever
3. Depth adjustment dial
4. Tool release buttons
5. Screw strip guide
6. Screw length scale
7. Nose
2
3
1
4
6
7
5
SPECIFICATIONS
OPERATION
FUNCTIONAL DESCRIPTION
ASSEMBLY
Adjusting the Depth of Drive
1. Remove the battery from the tool.
2.
3.
4. Install the extended PH2 bit into the screw gun.
5. Line up the collated attachment with the screw
gun and snap into place.
6.
To reduce the risk of injury,
always wear safety goggles or glasses with
side shields.
To adjust the depth of drive, rotate the depth of
drive dial. Continue adjusting the depth locator to
the desired depth.
To increase the driving
depth, turn the dial
clockwise
Installing Collated Screw Strips
WARNING
Attaching to the Screw Gun
Only use accessories specifically
recommended for this tool. Others may be
hazardous.
WARNING
1.
1.
To decrease the driving
depth, turn the dial
counterclockwise
2.
Using the Collated Attachment
Align the nose square
against the work surface.
Maintenance
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance
program. Inspect your tool for issues such as
undue noise, misalignment or binding of moving
parts, breakage of parts, or any other condition
that may affect the tool operation.
Cleaning
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain
cleaning agents and solvents are harmful to
plastics and other insulated parts. Some of these
include gasoline, turpentine, lacquer thinner,
paint thinner, chlorinated cleaning solvents,
ammonia and household detergents containing
ammonia.
1.
Pull the trigger and lock-on the tool according
to the screw gun's operator's manual.
2.
Push the tool forward smoothly to sink the
screw into the work surface.
3.
Lift the tool from the work surface. The next
screw in the strip is automatically moved into
place.
4.
To install , begin
feeding the screw
strip through the screw
strip guide (1).
2. Following the contour of the tool, feed the strip over
the gear wheel, through the nose of the tool (2).
3.
4.
NOTE: To remove screws, continue to pull forward
over the gear wheel. Do not pull out from the
bottom. This will damage the gear wheel.
1
2
The first screw will "click" into position.
.
.
To remove , remove battery pack and screws.
Press in the tool release buttons and pull the
collated attachment off of the tool.
2
1
1
Remove the nose cone from the tool.
Remove all bits and accessories from the screw
gun.