4
SYMBOLOGY
Volts
Direct Current
FUNCTIONAL DESCRIPTION
Single Sequential Actuation
Contact (Bump) Actuation
Read Operator's Manual
Wear Eye Protection
1. Workpiece contact
2. Jam latch
3. Trigger
4. Handle
5. Power/Actuation
selection
6. Hook
7. Magazine
8. Pusher
9. Pusher release lever
10. LED
11. Depth adjustment
ASSEMBLY
-
WARNING
Recharge only with the charger
WARNING
Always remove battery pack before
changing or removing fasteners.
Always wear safety goggles or glasses with side
shields.
To
install
fastener strips:
3.
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
the battery pack
Always lock the trigger or remove
any time the tool
is not in use.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
reco
Only use
mmended
accessorie
for thi
s
s tool. Others
may be hazardous.
Installing/Removing Fastener Strips
1. Remove battery pack.
2.
4.
5.
To
remove
fastener strips:
Slide the fastener strip into the nail slot and down
toward the front of the tool. Be sure the point of the
fasteners is pointed downward.
Press and hold the pusher release lever and slide
the pusher back past the end of the fastener strips.
Continue to hold the pusher, but release the lever.
Slowly slide the pusher forward until it rests against
the fastener strip.
OPERATION
WARNING
1. Remove battery pack.
2.
3. Press and hold the pusher release lever and slide the
pusher towards the front of the tool. Release the pusher.
4. Slide the nails back and out of the nail slot.
Do not dispose of electric tools
together with household waste
material. Electric tools and electronic
equipment that have reached the end
of their life must be collected
separately and returned to an
environmentally compatible recycling
facility.
Regulatory Compliance Mark (RCM).
This product meets applicable
regulatory requirements.
WARNING
Always point the tool away from
yourself and others when
installing fasteners. Failure to do so could result
in injury.
WARNING
Use only recommended
fasteners of the correct size,
length, collation angle and head type as indicated
on the tool's nameplate. Other fasteners could
result in tool malfunction, leading to injury.
WARNING
Always point the tool away from
yourself and others when
installing fasteners. Failure to do so could result
in injury.
To reduce the risk of injury,
always wear safety goggles or
glasses with side shields. The operator and
other people in the work area must wear eye
protection in accordance with AS/NZS 1337.1.
Eye protection does not fit all operators in the
same way. Make sure the eye protection chosen
has side shields or provides protection from
flying debris both from the front and sides.
To reduce the risk of injury to yourself and
others, test the tool before beginning work each
day according to the "Required Daily Testing"
section.
V
3
4
5
1
2
8
7
9
6
10
11