4
Cleaning
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain clean-
ing agents and solvents are harmful to plastics and
other insulated parts. Do not use sprays or solvents.
Some of these include gasoline, turpentine, lacquer
thinner, paint thinner, chlorinated cleaning solvents,
ammonia and household detergents containing am-
around tools.
ACCESSORIES
WARNING
Use only recom-
mended accessories. Others may be hazardous.
Extending/Collapsing the Legs
Always extend and lock legs before raising the poles.
1. Stand light upright.
2. Press the Leg Release Button and slide the legs
down using the Carrying Handle.
3. Lift up on the Upper Handle while sliding down the
Carrying Handle.
4.
legs lock into place.
5. To collapse, press the Leg Release Button and slide
in the legs using the Carrying Handle. Keep hands
clear of the legs as they collapse.
Extending/Collapsing the Extension Poles
Extend or collapse the two poles to set the light at the
desired height.
1. Extend and lock the legs.
2. Open the top extension latch and raise the head out
of the housing. Extend the pole to the desired height.
3. Fully close top extension latch.
4.
close latch before opening bottom latch.
5. Continue to raise the head to the desired height.
6. Fully close bottom extension latch.
7. Rotate the heads to the desired angle. The three
heads can be adjusted individually.
NOTE:
Before collapsing the poles, the heads must
be returned to their upright angle.
OPERATION
WARNING
To reduce the risk of
injury, do not look directly into the light when
the light is on.
Using the Light
1. Insert battery pack or plug into AC power.
2. Use the switch to cycle through High, Medium,
Low, and OFF. Press and hold to turn OFF from
any setting.
MAINTENANCE
WARNING
To reduce the risk of
injury, always unplug the charger and remove the
battery pack from the charger before performing
any maintenance. Never disassemble the tool,
battery pack or charger. Contact a
MILWAUKEE
®
service facility for ALL repairs.
Maintaining Light
Keep your light, battery pack and charger in good
repair by adopting a regular maintenance program. If
the light does not work properly, return the light to a
MILWAUKEE
®
service facility for repairs.
Tightening
,
n
o
it
i
s
o
p
r
i
e
h
t
d
l
o
h
t
o
n
l
li
w
s
n
o
i
s
n
e
t
x
e
r
o
d
a
e
h
e
h
t
fI
the screws may need to be tightened. Tighten the
bracket screws by holding the head. Tighten the ex-
tension latches by opening the latches and tightening
the screw inside.
WARNING
To reduce the risk of
personal injury and damage, never immerse your
tool, battery pack or charger in liquid or allow a
The light source contained in this luminaire shall
only be replaced by the manufacturer or his service
agent or a similar qualified person.
For a complete listing of accessories, go online to
www.milwaukeetools.com.au /
www.milwaukeetools.co.nz or contact a distributor.
