3
M
12
Cat. No.
Volts
DC
M
12 WWHH 7
12
SPECIFICATIONS
ASSEMBLY
WARNING
Recharge only with the
charger specified for the battery. For spe-
cific charging instructions, read the operator’s
manual supplied with your charger and battery.
Inserting/Removing the Battery
To
insert
the battery, slide the pack into the body
of the battery holder. Make sure it latches securely
into place.
Insert the power cable (from inside the battery
holder pocket) into the power cable port on the
battery holder.
Place the battery holder into the pocket and fasten
closed.
To
remove
the battery, push in the release buttons
and pull the battery pack away from the holder.
OPERATION
The power button is located on the upper left side
of the hoodie.
To
turn on
, press and hold the heated hoodie
power button (1 to 2 seconds). The hoodie will be
turned to High and the red LED will light.
Temperature setting can be
adjusted
at any time
by pressing the heated hoodie power button. Each
press will cycle through the heated hoodie’s tem-
perature settings.
To
turn off
the heated hoodie, press and hold the
heated hoodie power button until the LED turns off
(1 to 2 seconds).
If the heated hoodie turns off unexpectedly, check
connections and charge the battery pack.
SYMBOLOGY
Volts
Direct Current
Machine wash, Gentle Cycle in
warm water
Do not bleach
Do not wring or twist
Tumble dry, low heat
Do not iron
Do not dry-clean
M
12
CARE
WARNING
To reduce the risk of in-
jury, always unplug the charger and remove
the battery pack and battery holder from
the heated hoodie before performing any
maintenance. Never disassemble the heated
hoodie, battery pack or charger. Contact a
MILWAUKEE
®
service facility for ALL repairs.
M12
FUNCTIONAL DESCRIPTION
1. Power button
High: Red LED
Med: White LED
Low: Blue LED
2. Power cable
3. Battery holder pocket
4. Battery holder
5. Power Cable Port
M12
3
2
1
4
5
