4
Magazine
latch
Magazine
Magazine
channel
3. Push the magazine back in until it snaps closed.
OPERATION
WARNING
To reduce the risk of injury, always
wear safety goggles or glasses
with side shields.
1. Insert battery pack.
2. Set the power adjustment. Rotate towards
+
for
heavy-duty applications, rotate towards
-
for lighter
applications.
3. Line up the fastener to the workpiece. Press the
striker to the workpiece and squeeze the trigger
MAINTENANCE
WARNING
To reduce the risk of injury, always
unplug the charger and remove the
battery pack from the charger or tool before
performing any maintenance. Never disassemble
the tool, battery pack or charger. Contact a
MILWAUKEE
®
service facility for ALL repairs.
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage of
parts, or any other condition that may affect the tool
operation. Return the tool, battery pack, and charger
to a
MILWAUKEE
®
service facility for repair. After six
months to one year, depending on use, return the
tool, battery pack and charger to a
MILWAUKEE
®
service facility for inspection.
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work prop
erly, return the tool, charger and battery pack, to a
MILWAUKEE
®
service facility for repairs.
1. Striker
2. Power adjustment
3. Trigger
4. Battery bay
5. Belt clip
6. Magazine
ASSEMBLY
WARNING
Recharge only with the charger
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove battery pack before
changing or removing accessories.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
recommended for this tool. Others
may be hazardous.
Loading Fasteners
1. Pinch the magazine latch and pull magazine out
from tool.
2. Insert the fasteners into the magazine channel.
The fastener legs should point outwards away
from the tool body.
FUNCTIONAL DESCRIPTION
1
6
3
4
2
5