Milwaukee M12 2580-20, Operator'S Manual

Page: 17 / 110

13
3 M12™ Pipeline Locator Setup
3. M12™ Pipeline Locator Setup
This section of the manual covers setting up the features and options of the M12™ Pipeline
Locator.
3.1 Power on/off
Press the Power button on the M12™ Pipeline Locator. The buttons will illuminate,
showing that the power is on.
3.2 M12™ Pipeline Locator First Time Setup
All the settings are saved into the M12™ Pipeline Locator's memory and will remain there
until changed. The initial settings will set the FREQUENCIES, VOLUME, BACKLIGHT
TIMERS, SOUND CONFIGURATION, UNITS OF MEASURE, POWER TIMER, and
LANGUAGE.
3.3 Navigating through the Settings Menu
MENU Button - Press to enter the menu options. Also, use to step back
(return) to the previous screen.
UP and DOWN Navigation Buttons - Press the Up-Down buttons to move
vertically through the menu and to lower and raise the sensitivity while
locating.
SELECT Button - Press the SELECT button to accept the menu options.
3.4 Setting the LANGUAGE
It is recommended to set your LANGUAGE first so that the other menus can be easily
read and understood.
1. Press the Menu button to enter SETTINGS .
2. Scroll down to LANGUAGE , press the SELECT button to enter the LANGUAGE
sub-menu.
512Hz
Settings
Meter
5 min
English
Frequency
Speaker Volume
Backlight
Sound Configuration
Units
Auto Power Off
Self Test
Language
About
Bulgarian
Arabic
English
German
Dutch
3
3. Press the UP/DOWN buttons to highlight the LANGUAGE.
4. Press SELECT start the LANGUAGE change.