Assembly
Operation
Operating Instructions
Maintenance
Emptying Dirt Tray:
Assembly Instructions
Attach wall mount to a flat surface using the screws provided.
Insert the round end of the brush roller against the side-intake. Push the end
card of the opposite end of the brush roller into the channel until the end card
"snaps" into place.
Attach handle to the end of strut with the telescopic wand adjustment. Press
down on the locking tab, slide shorter strut over longer strut until locking tab
catches. Inset assembled handle into base until locks in place. Loosen the
telescopic wand adjustment to length and then tighten telescopic wand
adjustment.
Insert battery into battery compartment until it "snaps" in place. Connect the
power adapter and allow the unit to charge for 10 hours.
The LED charging display will light red when charging and the battery is
charged when the LED charging indicator changes from red to green.
NOTE: The unit will not charge if left in the ON position.
It is recommended that you remove the power adapter from the unit once the
unit has completely charged.
Press the " " switch on top of power head when ready to operate.
Place foot on power head and lean handle back gently to release lock for use.
Return handle to the full upright position to engage lock. NOTE: Do not operate the
unit while in the upright and locked position. Do not let the unit run while in a
stationary position for any period of time. Keep the unit moving while it is operating.
The performance of your new sweeper greatly depends upon care and maintenance.
The instructions in this manual will guide you in performing basic care and
maintenance. Read the instructions and keep them hardly for future reference.
Firmly grasp the unit at the handle base and with the other hand, press the dirt tray
lever release. NOTE: Make sure to have a firm grasp on the handle base and
carefully lay the handle flat.
Lift the dirt tray out of the unit and discard contents into wastebasket. Reinsert the
dirt tray into the unit. Grasp the handle base and carefully rotate it forward until it
locks into place.
4
5
