15
PAGE
INSTRUCTIONS
REPAIR
58-92-5305 d1
Assembly
Installing the
anti-vibration
mechanism
and field
1
Install field (6) into motor housing (8) and
secure it with two screws (7) (torque = 2
Nm / 18 in. lbs.).
2
Install following parts of the anti-vibration
mechanism into motor housing (8):
– vibration lever (3)
– spring (2)
– vibration spring cover (1).
3
Tighten anti-vibration mechanism with
screw (4) (torque = 3 Nm / 27 in. lbs.).
4
Insert air deflector ring (5) into motor
housing (8). Mind the right position!
Assembling
the electronic
component
1
Install the following parts:
– side handle plate (9)
– motor housing screws (8) (torque = 4
Nm / 35 in. lbs.)
– dial switch (E)
– two carbon brush holders (B)
☞
Insert end of flat spiral spring (G) into
slot (H) in pin of carbon brush holder as
indicated in enlargement of figure
(meaning: hook flat spiral spring (G)
into pin in “11 o’clock” position!).
Tension flat spiral spring by 1 turn in a
clockwise direction. Afterwards posi-
tion other spring end (I) onto carbon
brush holder (“ready position”).
☞
two switch screws (A) (torque = 1.3 Nm
/ 12 in. lbs.)
– two wires (D)
– four O-rings (C).
☞
Take care that no wires are jammed or
pinched.
☞
All wires must be correctly installed
between the cable entry lugs
(refer to wiring instructions).
2
Install switch (3) into handle half (F).
3
Install cord (7) and secure cord clamp (6)
with screws (5) (torque = 1.3 Nm / 12 in.
lbs).
4
Connect cord leads (7) to switch (3) and
secure screws (4)
(torque = 0.5 Nm / 4 in. lbs.).
5
Install handle half (2) and secure handle
half with four screws (1) (torque = 3 Nm /
27 in. lbs.).
1
2
3
4
5 6
7
8
3
4
5
6
D
8
9
A
B
C
E
7
1
2
F
G
H
I