21 cm
14.85 cm
Assembly Step
Installation
(c) Fan Blade Installation
• Locate flat surface at motor shaft.
• Insert Fan Blade to motor shaft with screw face to
flat surface.
• Tighten the fan blade screw.
Note: Please take note on the fan blade direction.
(d) Front Guard Assembly
• Insert screw into Guard Ring hole & turn clockwise by 2 cycle
• Assembly the Guard Ring and Front Guard
• Fit and match The Front Guard & Rear Guard together .
• Tighten up The Guard Ring screw .
(a) Wiring Diagram
3
4
(b) Regulator Wiring
(c) Assembly the unit
(i) Remove 4 screws as shown in figure A.
(ii)
• Remove 2 screws at side of the bracket (Figure B).
• Remove main bracket from fan (Figure C).
• Install bracket on the ceiling by using 2 wall plug.
• Put back main body into bracket and screw back side screw.
Note: Regulator is using Veriable Resistor system
(Speed 6 is the highest speed and speed 1 is the lowest speed)
Warning:
This product is not provided with cord and plug. When connect the appliances with power supply, it must installed by
qualified personnel in order to aviod hazard.
Neck Joint
Guard Ring
Guard Ring Cover
Figure A
Tongue
Groove
Black Wire
Wire
220V~/50Hz
Synchronise
Motor
Thermal Fuse
Brown Wire
MS1
~
Motor
C
N
L
Yellow / Green
Installation
L (Live Wire) L1 (Live Wire)
Input
Speed Control Switch
Model: MIAF-4020
Output
Note: Do not connect Natural
cable into the switch
Load Power:≤400W (Do Not Overload)
Batch No:2020150A
Natural Wire
(N)
2A 220V~
L(Live Wire)
Input
L1(Live Wire)
Output
Live Wire
(L)
C
B
Fixing Plate
Orbit Fan Installation Sheet
Expansion Bolts
