A complete Parts List is available at www.MillerWelds.com
OM-4426 Page 35
6-7. Remote Voltage/Amperage Control
1
Remote Receptacle RC4
Connect optional remote voltage/
amperage (V/A) control to RC4
(see Section 5-12).
With remote control connected,
weld output in a CC mode (Stick,
TIG) is determined by a combina-
tion of front panel and remote con-
trol voltage/amperage settings. In
CV mode (Wire), weld output is
controlled through remote control
only.
2
Remote Hand Control
(Optional)
3
Remote Foot Control
(Optional)
Engine runs at weld/power
speed in Wire mode whenever
a device connected to the re-
mote receptacle makes clo-
sure between pins A and B. In
all other modes, the engine
runs at idle speed until a load is
applied.
803 571
−
A / 216 170
−
A / S-0769 / S-0774
Process = Stick (Using Remote On/Off)
In Example:
2
Max = 160 A CC/DC
Min = 25 A CC/DC
Max (160 A DC)
Min (25 A DC)
Connect Remote
V/A Control To
Remote
Receptacle RC4
Set V/A Control
(Mid-Range: About 160 A)
Adjust Remote V/A Control
(Stick Welding Only)
3
1
Select Polarity By
Using DC Polarity/AC
Switch (If Present) Or
By Changing Cable
Connections
Switch
present on
AC/DC
models
only.
