OM-259 158 Page 11
1
Wire Guide Securing Screw
2
Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without touch-
ing. Tighten screw.
3
Drive Roll
The drive roll consists of two differ-
ent sized grooves. The stamped
markings on the end surface of the
drive roll refers to the grooves on the
opposite side of the drive roll. The
grooves closest to the motor shaft is
the proper groove to thread.
4
Drive Roll Securing Screw
Loosen screw and remove drive roll.
3-8.
Changing Drive Roll and Wire Inlet Guide
956142945-5-A
2.5 mm (0.1 in.)
Tools Needed:
Tools Needed:
1
2
3
4
3-9.
Aligning Drive Rolls and Wire Guide
!
Turn off and disconnect in-
put power
View is from top of drive rolls
looking down with pressure
assembly open.
1
Drive Roll Securing Nut
2
Drive Roll
3
Wire Guide
4
Welding Wire
5
Drive Gear
Insert screwdriver, and turn screw
in or out until drive roll groove lines
up with wire guide.
Close pressure roll assembly.
Ref. 800 412-A
Correct
Incorrect
4
3
2
1
5
Tools Needed:
