6
BACK WARNING LABEL
(FIG. B)
INSTALLATION
•
SEE INSTRUCTIONS FOR MOUTING
PROCEDURE.
•
ANCHORAGE AND MOUNTING HARDWARE
MUST BE CAPABLE OF SUPPORTING A 5,000
LB. (22kN) STATIC LOAD OR MEET OSHA
1926.502 REQUIREMENTS FOR A SAFETY
FACTOR OF TWO.
•
INSPECT BEFORE USE FOR ANY SIGNS OF
DAMAGE, WEAR OR MALFUNCTIONING
COMPONENTS.
•
DEVICE MUST BE TAKEN OUT OF SERVICE FOR
INSPECTION AND RECERTIFICATION AFTER
ARRESTING A FALL OR LOAD INDICATOR HAS
BEEN ACTIVATED.
BEFORE USING
•
CHECK LIFELINE RETRACTION BY PULLING
OUT A MINIMUM OF 4 FT. (1.2M.) OF LIFELINE
AND ALLOW IT TO RETRACT UNDER LIGHT
TENSION.
•
CHECK BRAKING ACTION BY GRASPING LIFELINE ABOVE LOAD INDICATOR AND APPLYING
A SHARP PULL TO THE LIFLINE. THE BRAKES MUST ENGAGE.
•
RELEASE THE TENSION AND ALLOW LIFLINE TO RETRACT SLOWLY INTO THE UNIT. THE
LIFLINE SHOULD RETRACT COMPLETELY.
•
ALLOW ADEQUATE FALL CLEARANCE BELOW THE WORK SURFACE WHEN USING THIS
DEVICE.
WARNING: MANUFACTURER’S INSTRUCTIONS SUPPLIED WITH THIS PRODUCT AT THE TIME
OF SHIPMENT MUST BE FOLLOWED: FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY OR
DEATH. ONLY FOR USE BY ONE PERSON AS A PERSONAL FALL ARRESTER. DEVICE MUST
BE TAKEN OUT OF SERVICE FOR INSPECTION AND RECERTIFICATION
**THIS SELF-RETRACTING LIFLINE SHOULD BE INSPECTED BY THE USER PRIOR TO EACH USE
ACCORDING TO MANUFACTURER’S INSTRUCTIONS.**
IDENTIFICATION LABEL
(FIG. C)
MODEL/LENGTH
MP20G/20FT (6.2m) · 3/16” (4.8mm) GALVANIZED STEEL CABLE
MP20SS/20FT (6.2m) · 3/16” (4.8mm) STAINLESS STEEL CABLE
MP30G/30FT (10m) · 3/16” (4.8mm) GALVANIZED STEEL CABLE
MP30SS/30FT (10m) · 3/16” (4.8mm) STAINLESS STEEL CABLE
MP50G/50FT (15m) · 3/16” (4.8mm) GALVANIZED STEEL CABLE
MP50SS/50FT (15m) · 3/16” (4.8mm) STAINLESS STEEL CABLE
MP65G/65FT (20m) · 3/16” (4.8mm) GALVANIZED STEEL CABLE
MP65SS/65FT (20m) · 3/16” (4.8mm) STAINLESS STEEL CABLE
DATE OF MANUFACTURE: MM\YY
SERIAL NO.: XXXXX
FIG. B
MODEL/LENGTH
MODELE/LONGUEUR
MPXXX/XXFT
DATE OF MANUFACTURE
DATE DE FABRICIATION
XX/XX
SERIAL NO/NO. DE SERIE
LB554 REV. A
FIG. C
