Miller Dynasty 400, Owner'S Manual

Page: 39 / 94

OM-275857 Page 29
�
Complete Parts List is available at www.MillerWelds.com
5-9. Gas Connections
2-6. 115 Volts AC Cooler Receptacle, Supplementary Protector CB1, And Power Switch
805593-A
1
2
3
2-7. Gas Connections
805593-A
3
2
4
1
OM-222 Page 1
allen_wrench
NGO’s
tools/
flathead philips head wrench
pliers
knife
heavy-duty workclamp light-duty workclamp wirecutter frontcutter
allen_set
needlenose
steelbrush nutdriver
chippinghammer
solderiron
stripcrimp
drill torque wrench
socket wrench
hammer awl file
crimper
paintbrush
feelergauge flashlight ruler
toothbrush
greasegun
qtip (swab)
vicegrip
handream
punch
filterwrench
strapwrench
airgun
solvent pinextractor eprompuller pipewrench
torque screwdriver
crescent wrench
11/16, 1-1/8 in.
1 Gas Fitting
Fittings have 5/8-18 right-hand threads.
2 Cylinder Valve
Open valve slightly so gas flow blows dirt
from valve. Close valve.
3 Regulator/Flowmeter
4 Flow Adjust
Typical flow rate is 15 cfh (cubic feet per
hour).
Connect customer supplied gas hose be-
tween regulator/flowmeter and gas fitting on
rear of unit.
5-10. TIG HF Impulse/Lift-Arc Connections
A complete Parts List is available at www.MillerWelds.com
2-8. TIG HF Impulse/ Lift-Arc Connections
805594-A
2
3
5
4
1
OM-222 Page 1
allen_wrench
NGO’s
tools/
flathead philips head wrench
pliers
knife
heavy-duty workclamp light-duty workclamp wirecutter frontcutter
allen_set
needlenose
steelbrush nutdriver
chippinghammer
solderiron
stripcrimp
drill torque wrench
socket wrench
hammer awl file
crimper
paintbrush
feelergauge flashlight ruler
toothbrush
greasegun
qtip (swab)
vicegrip
handream
punch
filterwrench
strapwrench
airgun
solvent pinextractor eprompuller pipewrench
torque screwdriver
crescent wrench
11/16 in. (21 mm for CE units)
Turn off power before making
connections.
1 Electrode Weld Output Terminal
Connect TIG torch to electrode weld output
terminal.
2 Gas Out Connection
Connect torch gas hose to gas out fitting.
3 Work Weld Output Terminal
Connect work lead to work weld output
terminal.
4 Remote 14 Receptacle
If desired, connect remote control to Remote
14 receptacle (see Section 5-4).
5 Gas In Connection
Connect gas hose from gas supply to gas in
fitting (see Section 5-9).