Complete Parts List available at www.MillerWelds.com
OM-282374 Page 34
258 836
!
Stop engine.
NOTICE
−
Do not exceed machine duty
cycle.
Welder B (right) weld output terminals
are disabled in Single Operator mode.
Connect only to Welder A (left) termi-
nals for Single Operator mode opera-
tion.
Use Single Operator mode for CC weld-
ing only. Welder B weld output terminals
are disabled in Single Operator mode.
(see Section 6-2).
See Section 5-15 for proper cable size.
1
Electrode Holder Cable
2
Work Cable
For Stick/TIG welding Direct Current Elec-
trode Positive (DCEP), connect work cable
to Negative (
−
) terminal and electrode hold-
er cable to Positive (+) terminal.
For Stick/TIG Direct Current Electrode Neg-
ative (DCEN), connect work cable to Posit-
ive (+) terminal and electrode holder cable
to Negative (
−
) receptacle.
Be sure Process Selector switch is set
correctly. See Section 6-4.
Tools Needed:
3/4 in.
Welder B (right) Terminals
Inactive In Single Operator Mode
1
2
Direct Current Electrode Positive
(DCEP) connections are shown.
Welder A (Left) Side
5-14. Making Single Operator CC Weld Connections