Instruction Manual
Page 9
CHAPTER 6
MAINTENANCE
5.0
Maintenance
Electrical Circuits
1. When replacing parts and components, you must use the part or components
of the same type as the original or equivalent to the original type. Original equipment
replacement parts should be purchased through Miller Weldmaster and or a Miller
Weldmaster authorize distributor.
2. To avoid damaging the control module, Display and Operating Panel, never plug or
unplug the cables connecting the PLC, Display and Operating Panel while the power
is on.
3. If there is any fault that cannot be removed, please immediately contact the service
department at Miller Weldmaster.
NOTICE: By not properly maintaining the machine, the performance may be effected. Please
contact Miller Weldmaster with any questions.
6.0
Transportation Specs and Storage
Storage
The manufacturer recommends that any time the machine is not in use, it must be protected from
excess dust and moisture. The operator should familiarize themselves with the warning symbols on
the machine to be alert to the potentially hazardous areas on the machine.
NOTE: The manufacturer will not be held liable for any damage or injuries occurring from any
inappropriate use of this machine.
