Instruction Manual
Page 5
CHAPTER 4
DEFINITION OF CONTROLS
Setup
Seam Temp Average:
This shows the average temperature that the Seam
Vision is capturing.
Sensor Delay:
Once the nozzle or wedge swings into position, the Sensor
Delay will delay the Seam Temp Average reading until set point is reached.
Sensor Delay will be adjusted by operator to desired setting.
Seam Temp High Alarm:
This will allow you to create a window that if the
Seam Temp Average rises above desired setting will trigger the Light Stack
signal and/or Bell Alarm. The High Alarm will be adjusted by operator to
desired setting.
Seam Temp Low Alarm:
This will allow you to create a window that if the
Seam Temp Average falls below desired setting will trigger the Light Stack
signal and/or Bell Alarm. The Low Alarm will be adjusted by operator to
desired setting.
Data Log:
This, when activated, will allow you to save any Seam Temp
data.
Transfer Data:
This will allow you to move any Seam Temp data collected
to a thumb drive.
Bell Alarm:
This will sound when Seam Temp Average falls below or rises
above the desired alarm settings window.
Delete Data:
This will allow you to get rid of any Seam Temp data
collected on a thumb drive.
3.0
Definition of Controls
Setup
Recipe
Recipe
Recipe Data Load:
When using different material this will allow you to
load different Seam Temp High/Low Alarm settings previously saved.
Recipe Data Edit:
This will allow you to edit previously saved Seam Temp
High/Low Alarm settings.
Recipe Data Save:
This will allow you to save the current Seam Temp
High/Low Alarm settings for different materials. You can save up to 10
products.
