OM-685 Page 3
Ref. 801 600 / Ref. 135 737-B
1
Bottom Tray
2
XMT Welding Power Source
3
Mounting Foot
XMT 300 Power Source (F)
Remove and discard mounting feet
from base. Use installation location
labeled F for XMT 300. Install using
supplied 5/16 in screws.
XMT 304, Dynsasty DX, Dynasty
300, Maxstar DX, Or Maxstar 300
Power Sources (G)
Use installation location labeled G
for these welding power sources.
Install using supplied 1/4-20 x 1/2 in
screws.
2
3
1
F
G
F
G
F
G
F
G
Tools Needed:
3/8, 1/2 in
Figure 3. Installing XMT Welding Power Sources
145 666-C / 802 400 / Ref. 800 297 / Ref. 801 575 / 180 842-E
1
Wrapper Mounting Hole
2
Bracket
3
Top Tray
4
Snap Start Control (D)
Remove and discard screws from
four wrapper mounting holes. In-
stall brackets using supplied 5/8 in
long sheet metal screws.
Locate four mounting holes labeled
D on tray. Install brackets on tray
using supplied 1/4 in screws, flat
washers, lock washers, and nuts.
5
Maxstar Welding Power
Source (D)
Locate four wrapper mounting
holes and install supplied brackets
using screws in wrapper.
Locate four mounting holes labeled
D on tray. Install brackets on tray
using supplied 1/4 in screws, flat
washers, lock washers, and nuts.
6
Millermatic 90 or 130
Welding Power Source (E)
Remove and discard screws from
center holes on sides of wrapper.
Install two brackets using supplied
5/8 in long sheet metal screws.
Locate two mounting holes labeled
E on tray. Install brackets on tray
using supplied 1/4 in screws, flat
washers, lock washers, and nuts.
1/2 in
Tools Needed:
4
5
6
1
2
3
3
E
D
D
E
D
D
3/8, 1/2 in
Figure 4. Installing Snap Start Control, Or Maxstar And Millermatic 90 Or
Millermatic 130 Welding Power Sources
