Miller Electric Millermatic 350P, Owner'S Manual

Page: 42 / 68

.
A complete Parts List is available at www.MillerWelds.com
OM-254915 Page 38
6-4. MIG Mode
Ref. 242 929-C
1 Lit Indicators
1
1 1
When the MIG light (2) is illuminated, the
unit is in MIG Welding mode.
SETUP
To enter MIG welding mode, depress the
SETUP (6) button once to go to GUN
selection. Rotate the right knob (9) to
select the gun being used. Select
MIG
for
standard MIG gun, or select
XR-A
,
PYTH, alpr
for push pull guns, or
SPL
for
spoolgun.
Depress SETUP (6) a second time to
illuminate the PROCESS (3) light. Rotate
right knob (9) until
MIG
is displayed (for
MIG only units
NOT USED
will be
displayed).
Depress SETUP (6) button again to
illuminate the WIRE (4) light. Adjust left
knob (8) to select wire type, adjust right
knob (9) to select wire size.
Depress
SETUP (6) button again to
illuminate TIMERS (5) light. For
description of the TIMERS , refer to
TIMERS menu (see Section 6-3-4)
If crater fill function menus are enabled,
TIMERS light will stay on to allow for ad-
justment of crater parameters and timers
(see Section 6-3-4).
Depress
SETUP (6) button again to exit
menus and enter MIG welding mode.
OPERATION
Adjust welding Voltage with left knob (8)
and Wire Feed Speed on the gun.
ARC CONTROL
MIG welding mode: Depress ARC
CONTROL (7) button to enter Arc control
menu and INDU will appear on the left
display and the corresponding setting will
appear on the right display. Adjust right
knob (9) to adjust inductance setting. In
MIG welding mode the Arc control is an
inductance control from 0-99. Changing
the inductance will change the fluidity of
the puddle.
Low Inductance High Inductance
Weld Bead Weld Bead
(0 setting) 99 setting