P.O. Box 159 • West Grove, PA 19390 • 800-220-3343 • 610-869-4422 • Fax: 610-869-4423 • www.milleredge.com
6809 South Harl Ave., Suite A • Tempe, AZ 85283 • 800-887-3343 • 480-755-3565 • Fax: 480-755-3558
3-
Learn Mode
3-1. Prior to mounting the Transmitter, remove the lid and insert the batteries, noting their polarity. The
green
power
LED should blink once every second. Press the
test
button, next to the green
power
LED, and note that the green
power
LED flashes rapidly 3 times.
3-2. To enter
learn mode
for channel 1, press and hold the
learn
button on the Receiver for ~2 seconds
until the yellow
status
LED blinks rapidly and both red
CH 1
and
CH 2
LEDs turn on.
3-3. Press the Transmitter
test
button for ~2 seconds. Note that the yellow
status
LED and the red
CH 1
LED on the Receiver blink rapidly. Immediately release the Transmitter
test
button. Channel 1 is now
programmed.
CH 1
LED will be blinking rapidly (indicating no edge has been connected) until your
10K sensing edge is connected to the Transmitter. Press the Transmitter
test
button again and note
that the red
CH 1
LED on the Receiver turns on solid.
3-4. To start over or erase programming, press and hold both
test
buttons for ~3 seconds until the yellow
status
LED stays on steady.
CH 1
LED will be blinking and
CH 2
will go out after ~15 seconds and
release. Both red
CH 1
and
CH 2
LEDs will blink slowly. Restart the
learn
procedure.
ANTENNA
8-PIN
CONNECTOR
MEL-II-RX10
MEL-II-RX10 CONNECTOR DIAGRAM
2-1. Turn the power off to the commercial door operator.
Mount the Receiver on or near the operator.
2-2. Attach the
antenna
to the Receiver. The
antenna
should be in line-of-sight of the Transmitter.
2-3. On the
8-pin connector
, connect the power source
(12-24 VAC/DC) to the terminals marked
power
(not
polarity sensitive). Next, connect the channel 1
COM
and the
pulsed
terminals to the operator photo eye
inputs (not polarity sensitive). The
output select
dip
switch 1 must be set to
P
. Switch 2 has no function.
2-4. Apply power to the Receiver. Observe that the green
power
and yellow
status
LEDs are on. The red
CH 1
LED will blink, and the
CH 2
LED will be on solid. After
15 seconds, the
CH 2
LED will go out. If the yellow
status
LED is blinking randomly, the Transmitter has
been learned and is working.
2-5. In limited instances, if you need to utilize the relay
output of
Ch 1
, instead of the
pulsed
output, simply
utilize the
10K/N.O.
and
COM
terminals (instead of the
pulsed
and
COM
) and set the output select to “R”.
FOR NORMALLY OPEN OUTPUT
The
P18
jumper on the Receiver circuit board will need to be
cut. Simply remove the 4 screws on the rear of receiver and
then remove 4 standoffs to access
P18
, which is located
near the
8-pin connector
.
2-
Install Receiver