5142019
16
STEP 1: Place the two (2) platform sections together as shown in Figure 16 and bolt together using four (4) 2 3/4” bolts, eight (8) wash-
ers, and four (4) locknuts. Make certain to place a washer under the head of each bolt and under each locknut. Tighten locknuts to 50
inch pounds.
STEP 2: Bolt the platform reinforcement tube to the bottom of the platform using two (2) 2 1/2” bolts, two (2) 2” bolts, eight (8) wash-
ers and four (4) locknuts as shown in Figure 17. Make certain to place a washer under the head of each bolt and under each locknut.
Tighten locknuts to 50 inch pounds.
STEP 3: Bolt two (2) hinges to the seat frame with two (2) 1 3/4” bolts, two (2) washers, and two (2) locknuts as shown in Figure 18.
Make certain to place a washer under each of the locknuts. From this point in the assembly, until the end, leave bolts loose until as-
sembly is complete. This practice will help ensure the assembly goes together easily.
Figure 16
Bolt Platform Together
Figure 17
Install Platform Reinforcement Tube
to Platform
Figure 18
Install Hinges to Seat Frame
Figure 19
Install Shooting Rail Adjusters
on Uprights
Figure 20
Install Tree Blade
STEP 4: Install the shooting rail adjusters on the uprights as shown in Figure 19 making certain the foot rest stop pegs on the lower end
of the uprights are facing in as shown in Figure 19.
STEP 5: Install the tree blade onto the uprights using four (4) 1/4” x 1 3/4” bolts, eight (8) washers, and four (4) locknuts as shown in
Figure 20. NOTE: The seat rivets must be facing upward.
STEP 6: Attach the platform to the uprights using two (2) 3” bolts, six (6) washers, and two (2) locknuts as shown in Figure 21. Make
certain to install a washer under the bolt head, the nut, and between the platform and the uprights as shown in Figure 21.
STEP 7: Install the two (2) vertical supports. NOTE: All seat hinge discs point to the right side on the stand as shown in Figures 23 &
24. Use two (2) 2” bolts, eight (8) washers, and two (2) locknuts as shown in Figure 22. Connect the vertical supports to the tree blade
before connecting to the seat hinges. Make certain to install washers under the head of each bolt, between the bracket, the vertical
support, and under the locknuts as shown in Figure 22.
Figure 21
Attach Platform to
Uprights
Figure 22
Install Vertical Supports
Figure 23
Connect Seat Hinges
