3262019
12
MILLENNIUM M-007-SL w/ M-102S RECEIVER COMPONENTS
A
B
C
E
F
G
Figure 15
Components of the Millennium M-007-SL w/ M-102S Receiver
MILLENNIUM M-007-SL w/ M-102S RECEIVER INSTALLATION
WARNING! Prior to installing your Millennium lock-on treestand, you must install a climbing system (i.e.,
stacking sticks, ladders, sectionals, etc.) which meets or exceeds industry standards recognized by the TMA.
Failure to follow these instructions may result in serious injury or death!
WARNING! Prior to attempting to use this or any other Millennium product(s) you must take a moment and
become familiar with it’s setup and installation at ground-level. You must practice installing, setting-up, removing,
and using this product(s) at ground-level prior to attempting to use it at heights above ground-level. Once you
have become thoroughly knowledgeable and comfortable with this Millennium product(s) setup, installation,
removal, and use at ground-level, you’re now ready to use it at heights above ground-level. Failure to follow
these instructions may result in serious injury or death!
WARNING! STOP NOW! Make sure you are wearing your full-body fall arrest harness and lineman belt as
shown in Figure 16. Failure to follow these instructions may result in serious injury or death!
STEP 1: Select a straight healthy tree, one devoid of dead branches with a minimum diameter of 9” (23cm) and one
that does not exceed 22” (56cm) in diameter at installation height.
NOTE: One very important note regarding the installation of your climbing system (i.e., stacking sticks, ladders, section-
als, etc.) which meets or exceeds industry standards recognized by the TMA. You must install the climbing system so the
steps extend a minimum of 2’ (24” [61cm]) (refer to Figure 17) above your standing platform height. This practice insures
you’re stepping off the top climbing stick down onto the standing platform. This practice also insures you have a firm and
secure hand-hold while stepping onto your treestand.
WARNING! Install your climbing system, which meets or exceeds industry standards recognized by the TMA, so they extend a minimum of
24” above the standing platform. Failure to follow these instructions may result in serious injury or death!
STEP 2: With your climbing system which meets or exceeds industry standards recognized by the TMA installed as outlined in the Manufac-
turer’s Instruction Manual, you are now ready to install your Millennium treestand. Always maintain three points of contact when climbing up/
down climbing systems. Always use a pull-up (hoist) rope to raise and lower your treestand. Never climb with anything on your back.
Figure 16
You Must Stay Connected
While Using This Product!
Standing Platform
Seating Platform
Cable Assemblies (2)
Receiver Tongue w/ R-Clip Installed
M-102S Receiver
R-Clip (not to scale)
Lower Tree Contacts (2)
Shoulder Straps (2)
A
G
H
F
E
D
C
B
(not shown)
D
