Millcreek 4300 TURF TIGER, Operator'S Manual

Page: 15 / 54

Operator's Manual: Millcreek Model 4300 TURF TIGER
®
Spreader
3-1
SECTION 3: OPERATION & ADJUSTMENT
Understanding TURF TIGER
®
Spreader Operation
Proper and safe operation of the Millcreek TURF TIGER Spreader requires: (1) understanding how the
spreader works, (2) being familiar with the spreader's operating components, and (3) heeding all safety
precautions as stated in this manual.
TURF TIGER™ spreader Tractor Driven Hydraulic models draw their power directly from the tractor
hydraulic system. For optimal operating performance, the hydraulic oil flow of 7 gallons per minute
(GPM) must be maintained. At 6 GPM, the spreader will still operate but at a slower speed. At flows
greater than 8 GPM, oil will be returned to the tractor reservoir by the spreader flow control valve.
The Optional PTO Hydraulic models include a hydraulic pump which draws power from the PTO
drive line to run the spreader hydraulic motors. The PTO hydraulic pump is designed to provide 7 GPM with a
PTO speed of 540 RPM.
TURF TIGER Spreader Operating Components
TURF TIGER spreader operation is controlled, in combination, by four variables:
(1) tractor ground speed (mph)
(2) endgate opening (up to 7 inches)
(3) apron belt speed (0 to 48 feet per minute)
(4) attachment speed
NOTE: The first three variables determine the application rate . The fourth variable affects the spreading
pattern .
The Dual Hydraulic Control Valves , located on the left rear side of the spreader, provide separate control of
belt and attachment speeds for maximum control and flexibility.
• The Front Control Valve controls the speed of the floor apron belt.
• The Rear Control Valve controls the speed of the spreading attachment.
Refer to Figure 3A on the following page for the locations of these components on the TURF TIGER spreader.