18G HDMI 2.0 Extender over CAT5e/6
4
2. Panel Description
Transmitter Panel Description
1.
CAT OUT:
Connects to the CAT IN port of receiver by CATx cable. It supports 12V
PoC and the transmitter can be powered from the receiver. The green LED
illuminates when power is applied. The orange LED illuminates when there is a valid
HDMI signal input.
2.
IR IN:
Connects to IR receiver for IR pass-through.
3.
IR OUT:
Connects to IR emitter for IR pass-through.
4.
RS232:
Connects to RS232 control device (e.g. PC) or a third-party device to be
controlled for RS232 pass-through.
5.
DISPLAY:
Connects to local HDMI display device.
6.
SOURCE:
Connects to HDMI source device.
7.
EDID:
3-pin DIP switch for EDID setting.
▪
MERGE: If there are two display devices in this system, the unit will output the
video with the lower resolution in this mode to ensure video can be shown on
both displays.
▪
BYPASS: The source device learns the EDID from the remote display connected
to the Receiver’s HDMI output.
▪
COPY Tx: The source device learns the EDID from the local display connected
to the Transmitter’s HDMI loop output.
8.
DC 12V:
DC connector for the power adapter connection.
Tx
Rx
SIG
ME
RG
E
BY
PA
SS
CO
PY
T
X
E
D
ID
1
2
3
4
5
6
7
8
