www.milesight-iot.com
www.milesight-iot.com
Step 2:
UG6x supports multiple LoRa antenna types. For internal antenna mode,
keep device positive outwards to ensure it can get good signal. For single external
antenna mode, rotate the antenna into the antenna connector and ensure the
antenna is installed vertically.
Step 3:
Install the power cable and Ethernet cable accordingly.
For two external antennas mode (UG67), rotate the antenna coaxial cable to one of
the connectors (ANT1 is recommended), then connect the antenna to coaxial cable.
When fixing the antenna, pass the antenna through the clamp and fix with screws,
then wrap the U-bolt around a pole and fix it to clamp with nuts and other accessories.
Note:
UG6x does not support hot plugging (also called hot swapping). Please turn
off the power before you insert or take off cards.
Please tighten the SIM dust cover of UG67 with wrench to prevent water into
the equipment.
Note:
For UG67, the external antenna must be installed on ANT1 connector.
For DC power supply, remove the protective cap of power connector and rotate the
DC power cable into the power connector.
1 6
1
7
Screw Bolt
Rubber Ring
Screw Nut
LAN
UG65:
After connecting the Ethernet cable and power cable to corresponding
interfaces, you can pass them through the waterproof silicone and slide into the
grooves. Then screw the protective cover back to the device.
UG67:
Pass the Ethernet cable through the cable gland and rotate the cable gland
to gateway, then tighten the cable gland with wrench.
