3
13. Make the snap connection, load 4 new
alcaline
AA
battery into holder (included with fireplace) then
feed back into junction box assembly.
DO NOT put batteries in the receiver, only in the
battery holder by the wall switch.
14. Test the operation of the wall switch.
Wall Switch Operation
The Wall Switch can be used to control the fireplace.
You can turn the pilot on or off and you can increase or
decrease the flame height.
Note that the thermostat and programming functions
are not available with the wall switch.
9. Locate and secure magnet plate using 2 ‘long’
screws provided.
10. Place and secure cover plate to box using 4 screws
provided.
11. Feed cable tie through the 2 side slots of battery
cover assembly.
12. Position battery holder to rear face and secure
together with cable tie. Note the clearance required
for battery snap connection.
Snap connector
Cable tie
Side slot
Rear view
Front view
• Press ON-OFF button once to light
pilot. Press again to shut of pilot.
• Press and hold large flame
button to gradually increase
flame height.
• Press and hold small flame button
to gradually decrease
flame height.
To turn appliance ON and OFF
To adjust flame height