10
3
Important Notes
Prior to the final installation, perform a sound check. If high distortion or intermittent sound
is experienced, it is possible that the wiring from the radio to the vehicles electrical system
is poor or that the battery needs recharging.
If the battery and its charging circuit are OK, then rewire the red fused wire of the radio
directly to the positive terminal (+) of the vehicle battery.
Marine accessory shops stock the connector blocks and the 10 Amp cable which may be
necessary for extending the fuse wire connection.
Make sure that the black wire on the wiring harness is connected to a good ground point on the
vehicle. If the chassis of the vehicle is used as a grounding point, make sure that the surface is
scraped clean from the metal before attaching the wire to it.
It is preferable to connect the black ground wire directly to negative terminal (-) of the vehicle
battery.
This model is only suitable for use in vehicles which have a negative ground system,
e. g.. : the negative terminal of the vehicle battery is connected to the chassis.
Before you wire your system, disconnect your vehicle battery's positive (+) cable. This helps
prevent damage in case of a short. When you complete the wiring, reconnect the battery cable
and test your marine stereo. When connecting your marine stereo's black ground wire, be sure
to connect the wire to a metal part of your vehicle or preferably to the negative (-) terminal of
the vehicle battery.
A microprocessor reset function has been provided to facilitate manual resetting of the internal
microprocessor. If you are faced with a malfunction during the operation, press and hold MODE
and Preset 1 buttons simultaneously for about 3 seconds to reset the unit.
Note: It will be necessary to re-enter the radio preset memories and other personal settings as
these will have been erased when the microprocessor was reset. After resetting the player,
ensure all functions are operating correctly.
1. Grounding
2. Warning: polarity...
3. Connecting the speakers and power cables
4. Reset Function
POSITIVE
CHASSIS
NEGATIVE
CHASSIS
1. USB Section Operation
2. Track seeking (12)
3. Play / pause (5)
4. Intro Scan (6)
5. Repeat Play button (7)
6. Random play button (8)
To
USB
, press MOD button (3)
While a track is playing, press Tune Up button to select the next track, press Tune Down
button to select the previous track.
While a track is playing, press and hold Tune up/down button to fast-forward or fast-rewind.
Press this button to pause playing. Press it again to resume play.
Simply press the INT button to hear the first 10 seconds of each track in the device.
Press and hold INT button for 2 seconds to Intro play the tracks in current folder.
Press the INT button again to return to normal play mode.
Simply press the RPT button to play the current track repeatedly.
Press and hold RPT button for 2 seconds to play the tracks in current folder repeatedly.
Press the RPT button again to return to normal play mode.
Simply press the RDM button to play all tracks in random sequence.
Press and hold RDM button for 2 seconds to play the tracks in current folder randomly.
Press the RDM button again to return the player to normal mode.
play
driver or USB device
momentarily or insert gently the
USB driver or USB device. It will automatically play MP3 files in the USB device and the
LCD display will show “USB PLAYING”.
If there are no files in USB device, it will be converted back to the previous mode after display
“NO FILE”.
USB Section Operation
3
2
12
13
5
6
8
9
10
11
1
4
14
7
AUX
MUTE
VO
L push SEL
MIL-MR60
