2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
1.
2.
3.
4.
Removing the top cover, insert plastic tool in one of the six holes, turn slightly to the side and twitch carefully to slightly release the cover from
holding into the place.
Continue to work around until all of the clamps are released.
Remove the top cover by lifting it up.
You will access the upper side of PCB and antenna, remove two black soft pads to access PCB holders.
Push both plastic holders to opposite sides to release the PCB board from its position.
Remove the PCB board, carefully lift it up and place it on the anti-static mat.
Locate the mini PCIe slot on the bottom of the PCB and remove two factory attached screws.
Attach provided a thick thermal pad to the card.
Install the card into a miniPCIe slot so that the thermal pad is between PCB and card.
The secure card in place using previously removed two screws.
Attach the grey uFL connector to the MAIN antenna connector of the modem, attach the black cable to the secondary (or AUX) connector. Use
silicone type rubber to secure wiring in place.
Attach a thinner thermal pad to the top of the card.
Reassembly in backorder.
After you have reinserted the device into the case, slide in the SIM cards from your mobile operator into the SIM slots, with the chips facing down.
Mounting
SXT designed to be mounted on the pole, the package includes mounting bracket and steel clamp.
With the clip pointed forward, slide the mounting bracket into the rail on the bottom of the case, until the clip clicks into place.
Guide the clamp through the opening in the bracket.
Attach the unit to a pole, with the Ethernet port pointing downward.
