www.routerboard.com
2
21/08/13
Buttons and Jumpers
•
ROS reset jumper hole (on the bottom of case, behind one of the rubber feet) – resets RouterOS software to
defaults. Must short circuit the metallic sides of the hole (with a screwdriver, for example) and boot the
device. Hold screwdriver in place until RouterOS configuration is cleared.
•
RouterBOOT reset button (RESET, front panel) has two functions:
o
Hold this button during boot time until LED light starts flashing, release the button to
reset
RouterOS configuration
(same result as with reset hole)
o
Hold this button during boot time longer, until LED turns off, and then release it to make RB750
look
for Netinstall servers.
Operating System Support
Currently tested operating system is MikroTik RouterOS (starting from v4.17).
Copyright and Trademarks.
Copyright MikroTikls SIA. This manual contains information protected by copyright law. No part of it may be
reproduced or transmitted in any form without prior written permission from the copyright holder. RouterBOARD,
RouterOS, RouterBOOT and MikroTik are trademarks of MikroTikls SIA. All trademarks and registered trademarks
appearing in this manual are the property of their respective holders.
Hardware
. MikroTik warrants all RouterBOARD series equipment for the term of one year from the shipping date to
be free of defects in materials and workmanship under normal use and service, except in case of damage caused by
mechanical, electrical or other accidental or intended damages caused by improper use or due to wind, rain, fire or
other acts of nature.
To return failed units to MikroTik, you must perform the following RMA (Return Merchandise Authorization)
procedure. Follow the instructions below to save time, efforts, avoid costs, and improve the speed of the RMA
process.
•
If you have purchased your product from a MikroTik Reseller, please contact the Reseller Company regarding
all warranty and repair issues, the following instructions apply ONLY if you purchased your equipment
directly from MikroTik in Latvia.
•
We do not offer repairs for products that are not covered by warranty. Exceptions can be made for RB1000,
RB1100 and RB1200.
•
Out-‐of-‐warranty devices and devices not covered by warranty sent to MikroTikls will be returned to the
sender at sender's cost.
RMA Instructions are located on our webpage here:
http://rma.mikrotik.com
Manual
. This manual is provided “as is” without a warranty of any kind, expressed or implied, including, but not
limited to, the implied warranty of merchantability and fitness for a particular purpose. The manufacturer has made
every effort to ensure the accuracy of the contents of this manual; however, it is possible that it may contain
technical inaccuracies, typographical or other errors. No liability is assumed for any inaccuracy found in this
publication, nor for direct or indirect, incidental, consequential or other damages that may result from such an
inaccuracy, including, but not limited to, loss of data or profits. Please report any inaccuracies found to
[email protected]
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
