Federal Communication Commission Interference Statement
List of FCC IDs
: RB921UAGS-5SHPacD-OUT (NetMetal), RB921UAGS-5SHPacT-OUT (NetMetal),
- FCCID: TV7RB921-5SHPACT; RB922UAGS-5HPacD-OUT (NetMetal), RB922UAGS-5HPacT-OUT
(NetMetal), RB922UAGS-5HPacD, RB911G-5HPacD, RB911G-5HPacD-OUT (NetBox) - FCCID: TV7RB922-5H-
PACT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a res-
idential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. This device and its antenna must not be co-located or operation
in conjunction with any other antenna or transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation.
63 cm minimum distance has to be maintained between the antenna and the occupational user and 140 cm to
general public. Under such configuration, the FCC radiation exposure limits set forth for an population/uncontrolled
environment can be satisfied.
List of additional approved antennas
• Omni Directional (fiberglass pole) WLO-2450-15 15 dBi
• Omni Directional (hor. polarization) HP, ODH 24-13 13 dBi
• Sector SA 24-90-17-WB 17 dBi
• Panel WLP-2450-20 20 dBi
• Dish DC 24-HD-PFIP 24 dBi
Antenna Installation. WARNING: It is installer's responsibility to ensure that when using the authorized antennas in
the United States (or where FCC rules apply); only those antennas certified with the product are used. The use of
any antenna other than those certified with the product is expressly forbidden in accordance to FCC rules CFR47
part 15.204. The installer should configure the output power level of antennas, according to country regulations and
per antenna type. Professional installation is required of equipment with connectors to ensure compliance with
health and safety issues.
See www.routerboard.com for more information. Contact [email protected] for support questions.
26 Oct 2016
