Please ensure the placement of the device in a dry and ventilated environment. Ingress rating IP20.
We recommend Cat6 cables for our devices.
Mounting and configuration of this device should be done by a qualified person.
Extension slots and ports
48 of Gigabit Ethernet ports supporting 802.3af/at PoE.
Four 10G SFP+ ports.
Two 40G QSFP+ ports.
1x RJ45 console port (set at 115200bits/s, 8 data bits, 1 stop bit no parity).
1x 10/100Mbit Ethernet port for management access.
Four cooling fans with automatic speed control.
Please visit wiki pages for MikroTik SFP module compatibility and configuration table:
https://wiki.mikrotik.com/wiki
/MikroTik_SFP_module_compatibility_table
Powering
The device accepts power from the input of 100 – 240 V AC .
Nominal voltage 53 V.
Nominal amperage 13.5 A.
The power consumption of this device under maximum load is up to 85 W. With attachments 800 W.
Power output
The device supports PoE 802.3af/at out from Ethernet 1 - 48 port, you can power Mikrotik devices which supports powering through Ethernet.
Output per port (53V out) 570 mA
Output per port (26V out) 1000 mA
Total output power 700 W
Total output current 27 A at 26 V, or 13,2 A at 53 V.
Configuration
RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself accustomed to
the possibilities:
. In case the IP connection is not available, the Winbox tool (
) can be used to connect to the MAC
address of the device from the LAN side. When using Winbox on login the default configuration settings will be shown.
CRS Router configuration manual
https://wiki.mikrotik.com/wiki/Manual:CRS_Router
For recovery purposes, it is possible to boot the device for reinstallation, see a section
Reset button
The RouterBOOT reset button has the following functions. Press the button and apply the power, then:
Release the button when the green LED starts flashing, to reset the RouterOS configuration to defaults.
Release the button when the LED turns solid green to clear all configuration and defaults.
Release the button after LED is no longer lit (~20 seconds) to cause a device to look for Netinstall servers (required for reinstalling RouterOS over
the network).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.
Useful for RouterBOOT debugging and recovery.
Accessories
The package includes the following accessories that come with the device:
