6
UNI-DS3 Development System
MikroElektronika
page
&RQQHFWLQJWKH6\VWHPWRD3&
6WHS
Prior to connecting the development system to a PC, it is necessary to install the appropriate USB driver essential for the proper
operation of the programmer. In addition to the USB driver, it is also necessary to install the appropriate program for loading a
.hex code into the microcontroller. Instructions for installing USB drivers are provided in the relevant manual accompanying the
development system (Quick guide for installing USB drivers).
6WHS
MCU card with the microcontroller must be placed into the DIMM-168P socket prior to connecting the development system to a PC.
6WHS
Use the USB cable to connect the
UNI-DS3
development system to a PC. One end of the USB cable, with a USB connector of
B
type,
should be connected to the development system, as shown in Figure 1-2, whereas the other end of the cable with a USB connector
of
A
type should be connected to the PC. When establishing a connection, make sure that jumper J11 is placed in the USB position
as shown in Figure 1-1.
6WHS
Turn on your development system by setting the POWER SUPPLY switch to the ON position. An LED diode marked as
POWER
will
be automatically turned on indicating that your development system is ready to use.
127(
If some additional modules are used, such as LCD, GLCD etc, it is necessary to place them properly on the development
system while it is turned off. Otherwise, either can be permanently damaged. Refer to Figure below for the proper placing of
the additional modules.
)LJXUH
Placing additional modules on the development system
)LJXUH
Connecting USB cable
1
2
)LJXUH
Power supply
Jumper J11 for selecting
power supply source
AC/DC connector
USB connector
POWER SUPPLY
switch
