HOW TO CLEAN THE MYST
ATTENTION!
ALWAYS POWER OFF AND UNPLUG THE DEVICE BEFORE CLEANING THE DEVICE.
WIPE THE SURFACE OF THE DEVICE WITH A SOFT AND DAMP CLOTH IF NEEDED.
WARNING!
• Do not clean the device with cleaning chemicals of any kind as they may
contain bleach. Use water, dish soap or vinegar solution ONLY.
• No touching or cleaning the PTC heater before it cools down in case of any
accidental injury.
Water tank
Remove the water tank cover, empty the water tank. Use water, vinegar
solution or dish soap to wash the inside of the water tank. Use a cloth or a
cleaning brush if needed, then rinse it until clean.
Water tank cover
Remove and wash the cover with water or vinegar solution. Use a cloth or a
cleaning brush if needed, then rinse it until clean.
Filter inside the water tank
Take out the filter set from the water tank. Wash the filter which may
accumulate large particles. After cleaning, assemble it back to the water tank.
Base
Follow the draining direction mark to pour excess water out of the base.
Clean the base with a cleaning brush or a soft damp cloth. DO NOT submerge
the base into water and AVOID water entering the base inside through the air
inlet or air outlet.
Ultrasonic transducer and PTC heater
ONLY use the enclosed cleaning brush to gently clean the ultrasonic
transducer and PTC heater to remove the build-ups and deposits thoroughly.
Do not scrub or scrape the ultrasonic disk and PTC heater.
