Always stop the engine before inspection
Fig. 1
Fig. 2
Fig. 3
Upper level
Lower level
(refil needed)
Oil gauge
Fig. 4
350cc
Oil plug
(14mm wrench)
7
．
INSPECTION BEFORE OPERATION
Part inspection sheet before work start
Check point
Visual inspection
Front cover & center cover
Fuel tank
Fuel system
Fuel filter
Engine oil
Vibration case oil
V-belt for vibrator
Oil pressure pipe line system
Traveling lever & part of system
Operation of traveling lever, rink origin
Bolt, nuts
Crack
、
Skewness
Falling off
、
Breakage
、
Crack
、
Looseness and falling off of bolt & nuts
Leak
、
Quantity of oil
、
Dirt
Leak
Dirt
Leak
、
Quantity of oil
、
Dirt
Leak
、
Quantity of oil
、
Dirt
Crack
、
Tension
Leak
、
Looseness
、
Crack
、
Abrasion
Falling off
、
Breakage
、
Crack
、
Looseness and falling off of bolt & nuts
Operation check
、
Permissible error
Looseness
、
Falling off
Check item
The check is details of engine is referred to engine instruction manual independently.
Set the machine on a level surface, then
remove the oil gauge of the vibrator. Check
the oil gauge to see if the oil is at the speci-
fied level. Use engine oil SAE10W-30 as
lubrication oil.
Recommended oil quantity is 350cc. (Fig. 4)
●
7.1 Engine Oil
7.2 Vibration Case Oil
CAUTION
！
11
Upper level Lower level
(refil needed)
Oil gauge
HATZ (1B20)
HONDA (GX160,GX200)
Set the engine on a level surface to check
the oil level.If the oil level is low, add oil.
(Fig.1)
Only lubrication can be done from the top
for HATZ engine (1B20). (There is no oil
gauge.) (Fig.2)
Use the following engine oil.
When pouring oil from the top (for 1B20D),
oil might overflow if large amount of oil is
poured at one time. So, pour slowly.(Fig.3)
●
※
Quality: Diesel engine oil, Grade CC or above
Gasoline engine oil, Grade SE or above
Viscosity: SAE No. 30 at 20°C and above (summer)
SAE10W-30
Oil inlet at the top
