17
First, if necessary, please match the direction by using servo reverse
in your radio. Then adjust the servo center positions using sub trim.
Finally, adjust the maximum servo travel using the servo throws in
your radio. The goal is to achieve on all 4 functions travels of 100%
as well as the correct servo travel direction.
Step 3: Tail Rotor Settings
In Step 3 of the setup procedure you can carry out the necessary tail
adjustments for the tail assembly. This includes choosing the correct
servo type. If your specific servo is not listed, please contact our
support team on the online VBar site (www.vstabi.de) to obtain the
appropriate setting.
In your VBar software, you can adjust the servo direction and the
limits for both directions. With no stick input, the tail servo is in neutral
position in setup mode. This helps to mount the servo arm at the best
angle possible. Then adjust the length of the tail rod in such a way
that the tail blades show 2-3° pitch. This is for torque compensation.
Now double-check the direction of the tail pitch. The nose of your heli
must move into the direction of stick input. If this is not correct, check-
mark the reverse box in your VBar software.
Check the mechanical limit sof the tail assembly carefully.
Summary of Contents for VBAR
Page 1: ...Manual V4 05 VBar...
