2
CAUTION: Height adjustment ring must be fully fastened before
the assembly of the motor section to the Internal pole.
HOW TO ASSEMBLE
Base and Pole assembly
1. Unscrew the spinner clockwise (or take the spinner out from the bag) and the plastic nut
counterclockwise to remove both of them. Fix the rear grill to the motor then tighten the plastic
nut again. (Fig. 5)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted Into groove of the blade.
Turn the spinner counterclockwise to tighten the blade. (Fig. 6)
3. Fasten the front grill and the rear grill by the grill clip and then tighten the fan grill locking screw
and nut. (Fig. 7)
Grill & Fan Blade Assembly
1. Unscrew the Bolt from the Extension Pole. (Fig.1)
2. Insert the extension pole into the chassis and tighten the Bolt. (Fig.2)
3. From the extension pole loosen the height adjustment ring and adjust the internal pole
to the desired height (Note: If you can't find the intemal pole, it must be inside the extension pole.
You can pull it out from the extension pole. (Fig.3)
4. To attach the head unit to the internal pole, loosen the thumb screw on the bottom of the head unit.
Place the head unit on the internal pole and tighten the thumb screw in alignment with the groove
on the internal pole. (Fig.4)
