1
Welding current/Arc voltage
Press the key and turn the control knob
to set the welding current.
Press the key for 3 seconds to display
the arc voltage (valid ONLY for TIG
DC and MMA DC). Press again “A” to
display the welding current.
2
Welding voltage
The LED shines when there is voltage
on MMA electrode or TIG torch.
3
Parameter units
The LED shines when the relevant
parameter unit is active.
4
Overheating indicator
The LED shines when the machine is
overheated.
5
Mains error
The LED shines if the mains voltage is
too high or too low.
6
Welding process
Choice of MMA/TIG.
7
Trigger mode
Choice of 2-stroke/4-stroke.
8
Current adjustment
Choice of torch adjustment.
9
Ignition method
Choice of HF/LIFTIG
®
ignition.
10
Gas pre flow (time)
11
Slope down
Time from welding current to stop
amp.
12
Gas post flow (time)
13
Pulse
Key activated = pulse.
14
Pulse setting
Press the menu key until the LED shines
at:
• Pulse time: Welding current period.
• Pause time: Base current period.
• Base current: % of pulse current.
15
Current type
Choice of AC or DC welding.
16
AC-t-balance, time-based
Time balance between positive and
negative half-wave is adjusted in %.
17
AC-electrode preheating
Automatic electrode preheating.
18
Choice of secondary parameters
Opens parameters 10, 11 and 12.
QUICKGUIDE FOCUS TIG 200
PFC
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
17
16
18
