- 9 -
Steel cutting producers used to manufacture with sharp edges. The
manufacturer has dealt with these sharp edges during production, however,
we insist the operator take care when in contact with this piece of equipment;
Always keep hands, hair and clothing away from heating source.
Wait the unit cools down before cleaning. Because the unit is too hot
to handle after using.
8. Operating Instructions
Before operating, make sure to place the unit horizontally by adjusting
bottom adjustable legs.
8.1、Lighting the pilot light
●To ensure thermostat is “OFF” before light;
●Turn safety valve knob to
“
PILOT
”
(Fig.5), press down by force and do not
loosen, then light the pilot fire(Fig.6), press and hold knob 30-45 seconds;
Loosen knob if pilot fire is lighting, otherwise relight and press knob
continually;
●When pilot light burns continually, turn knob to
“
ON
”
(Fig.7), without
press knob.
Fig.5 Fig.6 Fig.7
8.2、Igniting the main burner
●After light the pilot light, turn on the main fire valve by turning
temperature control knob clockwise, ignite the main burner by the pilot light,
turn temperature control knob to proper temperature according to user demand;
Ensure there are liquid edible oil or solid shortening in hydro-cylinder
before light the main fire;
Do not over the oil level line;
Do not ignite the main fire without any oil in hydro-cylinder to damage
equipment, even cause severe accidents;
8.3、Turn off the valve
●Turn temperature control knob to “OFF”, extinguish the flame of the main
fire burner;
●Turn safety valve knob to
“
PILOT
”
, this is in a standby state, the pilot
light is burning;
